| Service: |
Air and non-combustible, compatible gases (natural gas option available). Note: May be used with hydrogen. Order a Buna-N diaphragm. Pressures must be less than 35 psi. |
| Wetted Materials: |
Consult factory. |
| Housing: |
Die cast aluminum case and bezel, with acrylic cover, Exterior finish is coated gray to withstand 168 hour salt spray corrosion test. |
| Accuracy: |
±2% (-HA model ±1) of FS (±3% (-HA ±1.5%) on -0, -100PA, -125PA, -10MM and ±4% (-HA ±2%) on -00, -60PA, -6MM ranges), throughout range at 70°F (21.1°C). |
| Pressure Limits: |
-20 in Hg. to 15 psig.† (-0.677 bar to 1.034 bar); MP option: 35 psig (2.41 bar), HP option: 80 psig (5.52 bar). |
| Enclosure Rating: |
IP67. |
| Overpressure: |
Relief plug opens at approximately 25 psig (1.72 bar), standard gages only. See Overpressure Protection note on Catalog page. |
| Temperature Limits: |
20 to 140°F* (-6.67 to 60°C). -20°F (-28°C) with low temperature option. |
| Size: |
4″ (101.6 mm) diameter dial face. |
| Mounting Orientation: |
Diaphragm in vertical position. Consult factory for other position orientations. |
| Process Connections: |
1/8″ female NPT duplicate high and low pressure taps – one pair side and one pair back. |
| Weight: |
1 lb 2 oz (510 g); MP & HP 2 lb 2 oz (963 g). |
| Standard Accessories: |
Two 1/8″ NPT plugs for duplicate pressure taps, two 1/8″ pipe thread to rubber tubing adapters and three flush mounting adapterswith screws. (Mounting and snap ring retainer substituted for three adapters in MP & HP gage accessories.) |
| Agency Approval: |
Meets the technical requirements of EU Directive 2011/65/EU (RoHS II). Note: -SP models not RoHS approved. |
| Note: For applications with high cycle rate within gage total pressure rating, next higher rating is recommended. See Options Page. |
| *Low temperature models available as special options |
Reviews
There are no reviews yet.